Leading 10 usual forklift accidents ， forklift operation should take note of these matters ！.
Leading 10 usual forklift accidents ， forklift operation should take note of these matters ！.
Blog Article
Don't underestimate the forklift at the office. If the procedure is not good, there will be severe crashes in mins, and there are several crashes entailing forklifts.
Instance 1: The forklift freight obstructed the driver's sight, and the person in front could not be found, resulting in a rolling accident.
Case 2: In order to maintain the equilibrium of the forklift when raising hefty products, the workers used their body weight as the counterweight, which practically caused casualties.
Instance 3: The width of the forklift cargo surpasses the allowable width of the course and holds on the roadside shelf, which practically causes an accident.
Instance 4: Forklift is speeding up and rolls over during a turn.
Case 5: The forklift vehicle driver did not see the pedestrian, and the pedestrian did not observe the forklift.
Situation 6: The forklift lifts the employees unlawfully, the forklift chauffeur does not wear the seat belt, the forklift lifter drops and the motorist is crushed when the forklift surrender.
Situation 7: The forklift chauffeur did not wear a safety belt and fell from the vehicle when it surrendered and was crushed.
Forklift procedure must focus on these matters ：.
Beginning.
1. Before beginning, observe the environments, and after confirming that there are no barriers that impede the safety of driving, beep the horn first and afterwards begin.
2. For cars with hydraulic ( atmospheric pressure) brakes, the brake hydraulic stress (air pressure) scale must be secure before beginning.
3. When the forklift starts with a tons, the driver needs to first validate that the load is secure and reputable.
4. The beginning should be slow-moving and stable.
Driving.
1. When driving, the elevation between the bottom end of the fork and the ground must be maintained 300mm-400mm, and the mast must be slanted backward. .
2. Do not raise the fork too high when driving. When going into and leaving the work website or while driving, beware that there will certainly be no obstacles in the sky. When the lots is traveling, the fork should not be elevated too high, which will influence the security of the forklift. .
3. After unloading, the fork must be decreased to the normal driving setting prior to driving. .
4. When transforming, if there are pedestrians or vehicles close by, the driving signal should be issued first. High-speed sharp turns are banned. High-speed doglegs will cause the automobile to shed side security and tip over. .
5. When the forklift is downhill, it is strictly prohibited to shut off the fire and slide, and it is restricted to brake suddenly while driving with loads unless there are special scenarios.
6. When the forklift is running, it has to comply with the traffic rules in the factory and should keep a specific security range from the automobile ahead. .
7. When the forklift is running, the lots has to remain in the most affordable placement that does not prevent the driving, and the gantry needs to be properly slanted back. The lots will not be increased other than when stacking or packing. .
8. The height of the load must not block the vehicle driver's view. In unique conditions, when the thing impacts the forward vision, drive at a reduced speed when reversing.
9. It is prohibited to activate the ramp, neither to drive across the ramp. .
10. The safe driving speed of the forklift in the manufacturing facility location is 5 km/h, and it needs to drive safely at a low rate when getting in the manufacturing workshop area. .
11. When the forklift is lifted, raised or driven, it is prohibited for workers to stand on the fork to hold items and play a stabilizing function. .
12. If problems are found, they will certainly be fixed and reported in a timely manner, and they will certainly never operate with ailments or hide them.
loading and unloading.
1. When fork-loading things, the distance in between both forks ought to be adjusted as required to make the load of both forks balanced and not manipulated, and one side of the product should protest the rack. .
2. It is restricted to deal with a solitary fork or utilize a fork top or pull. In unique situations, safety and security warning signs must be established to remind bordering pedestrians. .
3. In the process of loading and unloading items, the forklift should be stopped with the brake. .
4. The speed of the lorry ought to be slow-moving and stable. Take care not to roll the wheels on the dunnage, so as not to stretch the rolled things and hurt individuals. .
5. When using a fork to fork the goods, the fork must be as deep as possible under the tons, and it needs to be noted that the fork pointer should not touch various other items or items. The lots should be supported with minimal back tilt of the gantry to ensure that the lots does not glide backwards. The mast can be slanted onward slightly when the tons is decreased to allow for simple positioning of the load and extraction of the forks. .
6. It is prohibited to fork items at broadband and ram hard objects with the fork head. .
7. When the forklift is functioning, it is prohibited for individuals to loaf the fork, so as to prevent the collapse of the goods and injure individuals. .
8. Straining is prohibited, and it is prohibited to utilize forks to raise workers to participate in high-altitude operations to stay clear of high-altitude dropping accidents. .
9. It is not allowed to make use of the brake inertia to slip, place, round or roll objects. .
10. It is not enabled to use forks to pick, transform pallet dump.
Leaving .
1. It is forbidden to leave the forklift when the products on the fork impend. Prior to leaving the forklift, you have to dump the goods or lower the fork Stand-on Electric Pallet Stacker framework.
2. Draw the parking brake handle to dead or depress the parking brake switch.
3. The engine is turned off and the power is cut off. (Except for special circumstances, such as the motorist does not leave the lorry's line of vision and does not exceed 1 minute).
4. Eliminate the trick. .
Forklift Operation Precautions.
1. Prior to and after the forklift operation, the appearance must be inspected, and gas, lubing oil and cooling water ought to be included.
2. Examine the safety and security performance of beginning, running and stopping.
3. Examine whether the lights and horn signals are total and effective.
4. During the operation of the forklift, inspect whether the stress and temperature are regular.
5. After the forklift is running, the outside leak ought to additionally be checked and the seals must be replaced in time.
Forklift Safety Operation Specifications.
1. You should examine before leaving the car;.
2. When you come across somebody in front of you throughout driving, you ought to send Stand-on Electric Pallet Stacker a signal at a distance of 5 m;.
3. The driving rate in the factory does not exceed 5 km/h;.
4. When driving, the nadir of the cargo need to be 0.3 m ~ 0.4 m in the air;.
5. The turning ought to not be as well sharp to avoid the propensity of "free switching";.
6. Adding and down the slope ought to be slow-moving and uniform, and no activating the slope is enabled.
7. Do not drive across the gradient. When the gradient is above 10%, the lorry must be driven backwards when going downhill;.
8. When the forklift employees lug the goods and progress, if they encounter large or hefty items and most likely to the chauffeur's line of sight, they ought to take the reversing workout
.
The "Eight Prohibitions" should be adhered to in the operation.
1. Single fork procedure is not permitted.
2. It is not permitted to raise the goods for cross country driving.
3. It is not allowed to grab the goods by turning over the pallet with the fork.
4. It is not enabled to directly shovel chemicals, flammables and other hazardous chemicals with forks.
5. It is not allowed to make use of inertia pressure to get the goods.
6. It is not permitted to utilize stopping force to expatriation round or easy-to-roll things.
7. It is not permitted to bring individuals to service the pallet or fork, and it is strictly forbidden to stand under the fork after the fork is raised.
8. Do not drive laterally on inclines
.
Auto parking is not permitted under the following conditions.
1. Curves, slim roadways, railway crossings;.
2. Areas with a longitudinal incline greater than 5%.
3. When there is an challenge on one side of the road, the contrary side of the area with the same length as the barrier must be within 20 meters at each end.
Web：https://www.onenforklifts.com/
Email：[email protected]
Phone：+86 13827083844